This is a
A single click on the program switch will confirm Inclusion and Exclusion.
This device take existing Z-WAVE signal, repeat and send it to a longer range where it is too far away for the controller (supporting FLiRS devices). Due to a special antenna amplifier the operating range will be up to 200 meters when installed correctly.
Install the mounting bracket in the vertical way as high as possible and fix the repeater.
Insert the suitable Micro USB Power Adaptor to the ZR1202.
It will go to the Learning Mode automatically. (The LED will start flashing which means the repeater has not been "Included" yet.)
Note: For indoor use only!
After installation use "Power Level Set" command for setting the strength of RF during one period.
It is also possible to use "Power Level Test Node Set" command to test the direct signal for fixed nodes.
Reset to factory default | XXXResetDescription |
Inclusion | single click on the program switch will confirm Inclusion and Exclusion. |
Exclusion | single click on the program switch will confirm Inclusion and Exclusion. |
NIF | A single click on the program switch will send out a Node Information Frame. |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0320000x0.0820000x0.0100000 mm |
Weight | 18 gr |
Firmware Version | 01.74 |
Z-Wave Version | 03.41 |
Z-Wave Product Id | 0109.2012.1203 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |