This is a
A single click on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. Releasing the tampering switch will wake up the device and keep it awake.
This sensor offers information whether a garage door is open or closed. It detect the horizontally or vertical position of the door. It is therefore required to mount it to the door in a way that it will also change the position from vertically to horizontally and back. The installation can be done with screws or double-sided tape. The device is battery-operated and therefore in sleeping mode unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. The units send information to a controller or any other associated Z-Wave device. Up to 5 devices can be controlled from this device. Two terminals allows the connection of an external dry contact in parallel to the position sensor. The powerful CR123 Lithium battery lasts 3 ... 5 years in normal operation conditions. The device supports normal Z-Wave inclusion, auto inclusion and network wide inclusion for convenient handling.
There are two options to mount the sensor. Double-sided tape can be applied to the mounting plate or the device itself. Screws however offer a more solid mounting and are stongly recommended for all security-related applications. The device need to be places in a way that the movement of the garage door results in a turning of the sensor so that the movement and the position can be detected.
The installed tilt sensor will send out a wireless signal every time the garage door is changing its position from open to close or back.
Reset to factory default | XXXResetDescription |
Inclusion | A single click for one second on the tampering switch inside the enclosure |
Exclusion | A single click for one second on the tampering switch inside the enclosure |
NIF | A single click on the tampering switch inside the enclosure will send out a Node Information Frame. |
Wakeup | Releasing the tampering switch will wake up the device and keep it awake. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Control Command when trip |
Dimensions | 0.0420000x0.0740000x0.0260000 mm |
Weight | 35 gr |
Hardware Platform | ZM3102 |
EAN | 0696859123412 |
Battery Type | 1 * CR123 |
Device Type | Routing Binary Sensor |
Generic Device Class | Binary Sensor |
Specific Device Class | Routing Binary Sensor |
Firmware Version | 04.54 |
Z-Wave Version | 03.28 |
Z-Wave Product Id | 0109.200a.0a02 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |