This is a
Inclusion, Exclusion and wakeup are confirmed by one second clicking the program switch inside the case.
This sensor monitors leakage and sends an alarm when flooding or leakage is detected. The sensing device can be away up to 2 m from the main device. The unit can be mounted on every flat surface. The installation can be done with screws or double-sided tape.
The device is a battery-powered device, which is in non-operating state unless an action is detected. After a programmable sleeping time the device wakes up and sends status information. After this the unit goes back to non-operating state. The unit will sends a warning to the Z-Wave controller, when batteries need to be replaced. The units send information to a controller or any other associated Z-Wave device. The device has a tamper switch which sends an alarm to the controller when it will be opened.
NOTE: A clean smooth surface is required to mount the Flood Sensor securely. The length of flood sensor cable is 2 meters. If the cable is too long, roll up the cable and fasten it by twist ties. The transceiver should be placed as high up as possible on the wall to improve communication and to prevent it from coming into contact with water in case of flooding.
Reset to factory default | XXXResetDescription |
Inclusion | Make sure that your Z-Wave Controller is in the Inclusion-/Exclusion-Mode. Click one second on the program switch inside the device to confirm the process. |
Exclusion | Make sure that your Z-Wave Controller is in the Inclusion-/Exclusion-Mode. Click one second on the program switch inside the device to confirm the process. |
NIF | Click one second on the program switch inside the device or a detected action by the sensor sends a Node Information Frame. |
Wakeup | Click one second on the program switch inside the device or a detected action by the sensor will wake up the device and keep it awake. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Flood detected |
Dimensions | 0.0420000x0.0740000x0.0260000 mm |
Weight | 35 gr |
Hardware Platform | ZM3102 |
Battery Type | 1 * CR123 |
Device Type | On/Off Power Switch |
Generic Device Class | Binary Switch |
Firmware Version | 0e.01 |
Z-Wave Version | 03.53 |
Certification ID | ZC10-14040002 |
Z-Wave Product Id | 0109.2005.0505 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |