TKB Home
Smart Plug in Switch
SKU: TKBETZ68-G
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
This plug-in ON/OFF switch in a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Each socket is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure the signal to ensure that the signal is received by its intended destination. You can use the button in the socket to include/exclude, manually on/off or act as a indicator. You can use it to turn on/off appliance remotely via smart home or computer.
Installation
Plug the device into the wall outlet.
Product Usage
Plug the device into the wall outlet and connect the load ot the device.
| Reset to factory default | 1. Press the socket on/off button three times within 1.5 seconds 2. then within 1 second to press and hold on for 5 seconds until the socket button LED is off, reset to factory default successfully |
| Inclusion | Press the socket on/off button three times within 1.5 seconds to be included to the controller |
| Exclusion | Press the socket on/off button three times within 1.5 seconds to be excluded from the controller |
| NIF | Press the socket on/off button three times within 1.5 seconds to be excluded from the controller |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | It can be associated by max. 5 devices.It can not associate other z-wave devices |
Configuration Parameters
Parameter 1: Indicator Light
Change the state of indicator light Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | LED is off as indicator the Load is off |
| 1 | LED is on as indicator when load is off |
Parameter 2: Memory function
Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Disable |
| 1 | The Socket status is the same as before when power off |
Technical Data
| Dimensions | 102*60*75 mm |
| Weight | 127 gr |
| Hardware Platform | ZM5202 |
| EAN | 6959174468663 |
| IP Class | IP 20 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Z-Wave Version | 6.51.06 |
| Certification ID | ZC10-15080005 |
| Z-Wave Product Id | 0x0118.0x0003.0x0002 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |