Quickstart

This is a Routing Multilevel Switch for XXXQFrequencyName. To run this device please connect it to your mains power supply.

Inclusion and Exklusion are confirmed by hitting the button one time.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The TKB TZ67 is a dimmer plug that can be placed between a wall outlet for Type G Plug and electric devices, plugged in by cord. It can dim resistive loads up to 300 W. The device is IP 20 rated and can therefore only be used in dry environments. For dimming the devices apply leading edge phase cutting. It is therefore only possible to dim incandescent lamps and high voltage halogen lights. Low voltage halogen lights, LEDs and CFLs must not be attached. Dimming is controlled wirelessly using Z-Wave or locally applying a button. A blue LED indicates the dimming status.

Installation

The Dimmer Plug can be plugged into every wall outlet for Plug-Type E. It is IP20 rated and can therefore only be used in dry environments. Do not locate the device facing direct sunlight, humid or dusty place. The suitable ambient temperature for the device is 0°C .. 40°C.

Product Usage

The device is able to dim electric load up to 300 W. Short press of the button will toggle. This means that the power will be turned on if it was off and turned off when it was on. When switching the lamp on or off the light will dim for about 2 seconds until the final level is reached.

The the button is constantly pressed the light will be dimmed. The dimming function will also toggle. Constantly pressing the the button will either dim up or dim down the light until it reaches the final level.

Reset to factory default XXXResetDescription
Inclusion

hit the button on the device.

Exclusion

 hit the button on the device.

NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 5 Lifeline

Configuration Parameters

Parameter 1: Indicator Light

Change the state of indicator lite
Size: 1 Byte, Default Value: 1

Setting Description
0 The LED is On, if the device is on
1 The LED is On, if the device is Off

Parameter 2: Memory function

Save the last status or not.
Size: 1 Byte, Default Value: 1

Setting Description
0 Do not save the last status
1 Save the last status

Technical Data

Dimensions 0.0600000x0.1000000x0.0750000 mm
Weight 135 gr
IP Class IP 20
Voltage 230 V
Load 300 W
Device Type Light Dimmer Switch
Generic Device Class Multilevel Switch
Specific Device Class Routing Multilevel Switch
Firmware Version 03.0c
Z-Wave Version 02.40
Z-Wave Product Id 0x0118.0x0202.0x0611
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeLight Dimmer Switch