Quickstart
This is a
Door Lock Keypad for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
Click [Add] icon in Z-Wave PC Conroller Program. Press the [REG] button for 3 seconds. (Ding dong -> Ding ding) Press the [*] button after pressing the [00[*] button.( Success : Ding dong dang, Fail : Ding dong Ding dong )
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Touch Screen Type Push Pull Door Lock. The Samsung SDS Z-Wave Door Lock is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enable Z-Wave Plus products.
| Reset to factory default |
All registered Master/User data will be deleted, and Master PIN Code is set to 1234. Also Z-Wave Door Lock is being removed from a network. Press the [REG] button for 3 seconds. (Ding dong -> Ding ding) Press the [*] button after pressing the [4560852580] button.(Success: Ding ding dang, Fail : Ding dong Ding dong) Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
| Inclusion |
Click [Add] icon in Z-Wave PC Conroller Program. Press the [REG] button for 3 seconds. (Ding dong -> Ding ding) Press the [*] button after pressing the [00[*] button.( Success : Ding dong dang, Fail : Ding dong Ding dong ) |
| Exclusion |
After exclusion from Z-Wave Netwokr, , it will no longer be remotely-controlled via the controller.Click [Remove] icon in Z-Wave PC Conroller Program.Press the [REG] button for 3 seconds. (Ding dong -> Ding ding)Press the [*] button after pressing the [00] button. (Success : Ding dong dang, Fail : Ding dong Ding dong) |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
1 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5101 |
| Device Type |
Door Lock Keypad |
| Network Operation |
Listening Sleeping Slave |
| Firmware Version |
01 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-15090016 |
| Z-Wave Product Id |
0x022E.0x0001.0x0001 |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
