This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Galaxy SmartTag2 - a compact tracker and location assistant for your personal belongings.
With AR Finding, you can use the SmartThings app on your compatible Galaxy smartphone or tablet to visually show you the way to a nearby item you are looking for. Even without AR Finding, you can easily find and navigate to items you have misplaced or lost.
If they are within Bluetooth range of up to 120 metres, you can use the SmartThings app on your smartphone to find their approximate location. Or you can simply ring the Galaxy SmartTag2 and it will tell you where it is with a loud acoustic signal. Locate objects even beyond the standard Bluetooth range (up to 120 metres).
Together with the SmartThingsFind network, you can extend the range and also locate lost pets.
The practical notification and warning function informs you when you move away from your personal belongings in the vicinity or from items that have been left behind. Or mark the Galaxy SmartTag2 as lost to leave contact details and a message for the finder.
Highlights:
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0290000x0.0360000x0.0090000 mm |
Weight | 12 gr |
EAN | 8806095039893 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |