LED Trading

LED Trading Inwall Module for momentary switch (Zigbee)

SKU: LEDZ9127


Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The LED Trading Inwall Module for momentary switch (Zigbee) integrates your existing light installation in your Smart Home. The module can be installed in the flushbox without any drilling. After the module has been mounted, you can connect it to your Zigbee enabled Smart Home Gateway. Afterwards, you can control the lights via a remote control, a voice assistant or with your Smartphone as well as with the existing momentary wall switch.

Make your home even smarter by integrating the module into your automations. Combine it with a motion sensor and the light will be turned on when motion is detected. Furthermore, you can control your lights with smart scenes. So, when you start a movie night with your beloved ones, the light will be turned off gently.

The LED Trading inwall module works with dimmable LED lamps or LED drivers with a maximum power of 200W. Incandescent lamps and halogen lamps with a maximum power of 400W can be also connected.

Specifications:

  • Flush-mounted Zigbee switch
  • Integrates existing installations (lighting or other devices) into a Zigbee network
  • Connection to universal momentary switch with 8-230V 
  • Supports capacitive and ohmic loads
  • Maximum load: 200W for LEDs, 400W for incandescent lights
  • Output voltage: 100-230V, max. 1,5 A 
  • Power supply: 100-230V, 50Hz
  • Wireless technology: Zigbee 3.0
  • Frequency: 2,4 GHz
  • IP-class: IP20
  • Compatible with SmartThings, Aeotec Smart Home Hub, Philips Hue, Amazon Echo Plus, Home Assistant (with Zigbee Stick)

Download high resolution images for LED Trading products.

 

 
Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0450000x0.0450000x0.0210000 mm
Weight 36 gr
EAN 4260567171919
Frequency XXfrequency
Maximum transmission power XXantenna
Z-Wave Device