This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
The AM160 from iEAST with its elegant aluminium case is the optimal partner for every music enthusiastic. Connect to your home network the AM 160 allows you access to all internet radio stations and music stream services. Comparison to the M5 & M30 from iEAST this version offers the possibility to operate two passive speakers.
Like models M5 & M30 the AM160 is also multiroom enabled. Therefore you can connect with every device separated or together. All iEAST device are synchronized and create a unique sound experience. Furthermore you can assign rooms to each device and combine different rooms with each other. Every audio channel can also be controlled separately.
The iEAST AM160 module upgrades your speakers into modern network speakers. Enjoy music in the complete house and control it from everywhere. In the times of music streaming that is a great addition to your Smart Home.
The iEAST Multiroom devices are compatible to the Fibaro Homecenter 2, the POPP Hub 2 and the Razberry with Z-Way. So your Smart Home System can be connected with your sound system.
Functions:
Network properties:
Audio system:
Output signal:
Max. output signal:
Supported files:
Music sources:
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.1170000x0.0382900x0.2000000 mm |
Weight | 1442 gr |
EAN | 6970504260047 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |