This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
The Foscam FI9826P is one of Foscam"s plug and play, 1.3 megapixel indoor camera with 3x optical zoom. The optical zoom feature allows you to physically zoom in on objects with amazing clarity and without losing picture quality. The plug and play feature allows the ability to connect via smartphone by simply scanning the QR code on the underside of the camera. Bypassing the need to access your router and setup port forwarding, the FI9826P can be set up effortlessly by anyone, even those with very little IT experience.
The FI9826P features 1280 x 960p video resolution, h.264 video compression, 3x optical zoom, built-in DVR via SD card (upto 32gb), two-way audio, wifi-N capability, pan/tilt, remote internet viewing, motion detection, night-vision as well as network video recording capability. In addition, it is smartphone compatible (iPhone, Android - app required) as well as viewable over the internet using standard browsers on PC (Firefox, IE & Chrome) or Mac (Safari only). The camera functions well as a smartphone baby, pet or elderly parent monitor or as part of a complete home/office security system with remote internet monitoring ability
P2P Funktion ( easy installation for Smartphones )
960P HD Indoor IP Kamera with Zoom
Free DDNS for a direct Access from the internet
1280 x 960 px
13 IR LEDs for Nightvision
Wireless 11n standard
H264 video compression
pan & tilt camera
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.1270000x0.1270000x0.1020000 mm |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |