Eutonomy

Eutonomy - euFIX S214 DIN adapter (with button)

SKU: EUT_EUFIXS214


Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

euFIX adapters facilitate the integration of FIBARO system into building infrastructure: in homes, offices, warehouses and hotels.

You can use the euFIX S214 Adapter to install the FIBARO® Switch FGS-214 module on DIN TH35 type rail in your electrical switchboard. The euFIX S214 Adapter consists of the case and the base board, where the FGS-214 module is mounted. The dimensions of the case are appropriate for a standard DIN TH35 type rail. The base board contains a set of screw terminals, where you can safely connected all the wires (power supply, input and output signals, control push-buttons). The front panel of the case contains two diagnostics micro-push-buttons S1 & S2, which you can used to control or to register the FIBARO® module within your Z-Wave system. Also you can remove it from the system without opening the adapter"s case.

Specifications:

  • Suitable for FIBARO® FGS-214
  • Supply voltage: 230V, 50/60Hz
  • Load power: max 6.5 A (resistive load)
  • Dimensions: 34.8 x 87.3 x 64.7 mm
  • Conductor wires cross section: max. 2.5 mm2
  • Operating temperature: 0 °C to +35 °C
  • Relative humidity: ?95 %, no condensation

Download high resolution images for Eutonomy products.
Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0350000x0.0880000x0.0600000 mm
Weight 58 gr
EAN 5906874103661
Frequency XXfrequency
Maximum transmission power XXantenna
Z-Wave Device