Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

With the WiDom Dimmer you get the possibility to integrate existing switchable and dimmable electric installations such as lighting or ceiling fans into your Z-Wave network. Thus, the connected load can be switched and dimmed via Z-Wave or with your existing toggle or momentary switch. 

Make your lamps smart with the WiDom Dimmer. The following types of lamps can be controlled by the WiDom Dimmer:

  • Traditional incandescent and halogen bulbs
  • Dimmable energy-saving CLF fluorescent bulbs
  • Dimmable LED bulbs
  • Dimmable Low voltage bulbs with transformer

The compact radio module is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as an input device for the WiDom Dimmer that is controlling the load. The switch only sends control signal to the insert which controls the load. With your gateway you also can define different times when the lamps shall turn ON or OFF. 

With the LED you get feedback directly if the electrical connections are correct. Thus the installation is much more easy. Furthermore the WiDom Dimmer acts as a repeater and increases the reliability of your Z-Wave network. Equipped with a very precise power metering funcionality as well as overheat protection mode it is ahead of competing products.

Features:

  • Flush-mounted trailing edge Z-Wave Dimmer
  • Integrates existing installations (lighting, ceiling fans) into the Z-Wave network
  • Suitable for different lamp types (halogen, LED, CLF fluorescent, etc.)
  • Works with every type of switch
  • Even with small loads, there will be no flickering
  • Power metering function
  • Overheat protection (turn off the load when the temperature exceeds a certain level)
  • Power supply: 110 - 230V, 50/60Hz
  • Power consumption: < 1W
  • Maximum load: 300W
  • Wireless technology: Z-Wave Plus
  • Dimensions: 37x37x17mm

We would like to point out that this article is not a new product. The product has got the complete functionality and can be integrated into a Z-Wave Smart Home without restriction. However, the product may have the following characteristics:

  • broken seal,
  • damaged packaging,
  • no original packaging,
  • missing accessories,
  • minimal signs of wear,
  • no current software version.

We offer to you a guarantee of one year. With a possible return you receive a credit note, there is no exchange of the product. The picture may not correspond to the scope of delivery of the product. If you are interested in a larger quantity of used products, please contact your sales representative.

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0377200x0.0371300x0.0182300 mm
Weight 23.23 gr
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeZ-Wave Device