This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
The Philio Sensor is a 2-in-1 Sensor. The sensor measures the humidity (in percent) and the temperature (in Celsius) of its environment. Furthermore the sensor has a tamperswitch, which works as a burglar alarm. By using Z-Wave all the information is transfered to the Gateway.
The 2-in-1 Sensor can be mounted on almost every surface in horizontal or vertical position. The sensor has a casing with a barred aperture for the measurement of the humidity. On the backside of the case there is the tamperswitch, which works as burglar alarm if the device is moved or manipulated.
With the Philio sensors you can easily make your home smarter and safer. The sensors are small, inconspicuously and fit on every surface. If you want to protect your home from burglars or other dangers like fire or water you can easily integrate the Philio Sensors to your Z-Wave Smart Home gateway.
Features:
We would like to point out that this article is not a new product. The product has got the complete functionality and can be integrated into a Z-Wave Smart Home without restriction.
However, the product may have the following characteristics:
We offer to you a guarantee of 1 year. With a possible return you receive a credit note, there is no exchange of the product.
The picture may not correspond to the scope of delivery of the product.
If you are interested in a larger quantity of used products, please contact your sales representative.
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0280000x0.0230000x0.0850000 mm |
Weight | 35.06 gr |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |