This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
The quiet death - protect yourself from it!
The Carbon Monoxid Sensor of HEIMAN will make your home safer and prevents danger caused from the ‘silent killer’ carbon monoxide (CO). The sensor detects carbon monoxide in the air and alarms in case of exceeded limits with an alarm sound of 85 dB as well as an optical signal. Its high sensitivity allows to detect the presence of the CO gas at the early stage in order to prevent carbon monoxide poisoning.
The most common applications are in kitchens and in the area of stoves or fireplaces. But did you know that even in a bathroom that cannot be ventilated regularly, there is a risk of CO?
Additionally to the acoustical and optical alarm signal, automatic scenes can be triggered within the Z-Wave gateway and notifications can be sent. The battery operated device alerts you also if the battery charge level is low and offers a battery lifetime of approx. 3 years.
We would like to point out that this article is not a new product. The product has got the complete functionality and can be integrated into a Z-Wave Smart Home without restriction.
However, the product may have the following characteristics:
We offer to you a guarantee of 1 year. With a possible return you receive a credit note, there is no exchange of the product.
The picture may not correspond to the scope of delivery of the product.
If you are interested in a larger quantity of used products, please contact your sales representative.
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
|Frequency||Europe - 868,4 Mhz|
|Maximum transmission power||5 mW|