Aqara

Aqara Roller Shade Driver E1

SKU: AQAZRSD-M01


Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

Aqara Rollo-Driver E1 is a retrofit roller blind controller that requires no complicated installation and can work with your existing roller blind by activating the bead cord. It requires no dedicated wiring and can be connected to a power supply both wirelessly via the built-in rechargeable battery and via the included USB Type-C cable.

Features:

  • Wireless Protocol: Zigbee 3.0 IEEE 802.15.4
  • Operating Temperature: -10°C ~ 55?
  • Operating Humidity: 0 ~ 95% RH, no condensation
  • Package contents: Aqara Roller Shade Driver E1 × 1, Screw × 2, Expansion Tube × 2, Double-Faced Adhesive Tape × 1, Spare Rotating Plate × 3, USB-C to USB-A Cable × 1
  • Battery Type: Lithium battery (not replaceable)
  • Input Power: 5V?1A
  • Total Power Consumption: 5W
  • Standby Time: Two months (supposed to control a roller shade of 1.8m*1.8m up and down once a day)
  • Standard: GB/T 12350-2009
Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0420000x0.1650000x0.0370000 mm
Weight 379 gr
EAN 6970504215085
Frequency XXfrequency
Maximum transmission power XXantenna
Z-Wave Device