Quickstart

This is a On/Off Power Switch for XXXQFrequencyName. To run this device please connect it to your mains power supply. To add this device to your network execute the following action:
1.Put your system controller into inclusion mode by following the instructions provided by your controller manufacturer.2.Press the push Off/On button located on the front of the device three times within 1.5 seconds.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from Z-Wave Alliance Product data and may be incomplete. Please refer to the Manufacturers Manual for more information.

Product Description

IndependenceGewa Andromeda socket is specially adapted for disabled people who want to live a more independent life, such as wireless, can turn on/off lights, turn on/off various devices and can easily be moved between different outlets.Flexible control modesIt can be controlled in three different ways, with an IR transmitter (GewaLink system), a radio transmitter (Z-Wave) or a connected control switch.Built-in on/off buttonAndromeda Socket also has a built-in on/off switch that makes you always can operate the device even if one has no IR/radio transmitter. It also has a blue indicator light that shows if the switch is on.Easy to programIt is easy to program, as is done with the built-in on/off button.Andromeda socket available in different versions for different countries.Technical dataOperating voltage: 230V AC, 50 HzMaximum load: 3600VA 16A resistive loadProgramming Channels IR: GewaLink channelsRadio: Z-waveRadio frequency: 868.42 MHzSocket for control switch: 3.5 mm (2-pole mono female)Operating environment: indoors (IP 21)Dimensions: 53 x 122 x 43mm (excluding connector plug)

Reset to factory default Note: Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.1.Press and hold the push button located on the front of the device for approx. 6 seconds until the LED's is steady.2.Release the button and press ones again within 3 seconds.
Inclusion 1.Put your system controller into inclusion mode by following the instructions provided by your controller manufacturer.2.Press the push Off/On button located on the front of the device three times within 1.5 seconds.
Exclusion 1.Put your system controller into exclusion mode by following the instructions provided by your controller manufacturer.2.Press the push Off/On button located on the front of the device three times within 1.5 seconds.
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 5 Z-Wave Plus Lifeline, DEVICE_RESET_LOCALLY_NOTIFICATION, SWITCH_BINARY_REPORT

Technical Data

Hardware Platform ZM5101
Device Type On/Off Power Switch
Network Operation Always On Slave
Firmware Version 04
Z-Wave Version 6.51.06
Certification ID ZC10-15100023
Z-Wave Product Id 0x0117.0x0001.0x0080
Frequency XXfrequency
Maximum transmission power XXantenna
CEPT (Europe)On/Off Power Switch