Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Follow the instructions for you Z-Wave certified controller to include the smart switch to the Z-Wave network. 2. Once the controller is ready to include your outdoor smart switch, press and release the manual/program button on the smart switch to include it in the network.3. Once your controller has confirmed that the smart switch has been included, refresh the Z-Wave network to optimize performance.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Transform any home into a smart home with the Jasco Z-Wave Outdoor Smart Switch. The lighting control enables wireless control of on/off functions for outdoor applications, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. The weather-resistant housing with a protective outlet cover safeguards the outlet from dirt and debris when not in use. The discreet black color blends in with any outdoor environment. Perfect for decorative or seasonal lighting, fountains and other outdoor plug-in appliances. Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
| Reset to factory default |
1. If plugged in, unplug the Switch from the receptacle. 2. Press and hold the top button for at least 3 seconds while you plug the switch into a receptacle. Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
| Inclusion |
1. Follow the instructions for you Z-Wave certified controller to include the smart switch to the Z-Wave network. 2. Once the controller is ready to include your outdoor smart switch, press and release the manual/program button on the smart switch to include it in the network.3. Once your controller has confirmed that the smart switch has been included, refresh the Z-Wave network to optimize performance. |
| Exclusion |
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network. 2. Once the controller is ready to Exclude your device, press and release the manual/program button on the smart switch to exclude it from the network. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Z-Wave Plus Lifeline |
| 2 |
5 |
Supports Basic Set and is controlled with the local load. |
| 3 |
5 |
Supports Basic Set and is controlled by double pressing on/off button. |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
On/Off Power Switch |
| Network Operation |
Always On Slave |
| Firmware Version |
HW: 255 FW: 5.21 |
| Z-Wave Version |
6.51.10 |
| Certification ID |
ZC10-17085740 |
| Z-Wave Product Id |
0x0063.0x4F50.0x3033 |
| Firmware Updatable |
Updatable by Consumer by RF |
| Outdoor Use |
ok |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
