Heatit
Heatit Z-Dim2
SKU: Z-Dim2
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Heatit Z-Dim2 is a Z-Wave rotary dimmer for many different types of light fixtures. The Heatit Z-Dim2 works on most low loads without causing flickering.The dimmer is equipped with an external switch option. This allows you to dim and turn on/off the load from an external switch.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | |
| 2 | 5 | |
| 3 | 5 |
Configuration Parameters
Parameter 1: Power restore level
Power restore level Size: 1 Byte, Default Value: 100
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 10: Load dimming mode
Load dimming mode Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 11: Maximum dim level
Maximum dim level Size: 1 Byte, Default Value: 90
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 12: Meter report threshold
Meter report threshold Size: 1 Byte, Default Value: 10
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 13: Meter report interval
Meter report interval Size: 2 Byte, Default Value: 780
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 2: Switch ON level
Switch ON level Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 3: Automatic turn OFF
Automatic turn OFF Size: 4 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 4: Automatic turn On
Automatic turn On Size: 4 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 5: Turn off delay time
Turn off delay time Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 6: Rotary wheel press functionality
Rotary wheel press functionality Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 7: External switch functionality
External switch functionality Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 8: Dimming duration
Dimming duration Size: 1 Byte, Default Value: 50
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 9: Choose the dimmer curve
Choose the dimmer curve Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Technical Data
| Hardware Platform | ZGM130S037HGN2 / ZGM130S037HGN1 |
| Device Type | Multilevel Switch DT |
| Network Operation | Always On Slave |
| Firmware Version | HW: 01 FW: 01.20:00.01 |
| Z-Wave Version | 7.16.3 |
| Certification ID | ZC14-22060111 |
| Z-Wave Product Id | 0x019B.0x0004.0x0004 |
| Switch Type | Rotary Knob |
| Z-Wave Scene Type | Central Scene |
| IP (Ingress Protection) Rated | ok |
| Neutral Wire Required | ok |
| Firmware Updatable | Updatable by Consumer by RF |
| Electric Load Type | Dimmable LEDIncandescent |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |