Philio
In Wall Micro Dimmer
SKU: PAD19-HK
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
PAD19 is a 2/3 Wire dimmer.It can only needs to connect two wires, single wire (L) and load (NO1),or three wires, two wire (LN) and load (NO1)
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | |
| 2 | 5 |
Configuration Parameters
Parameter 1: Power-on recovery status set
To set dimmer level when AC power on. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 2: RF report set
To set device send report to gateway Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 3: Maximum level
To set dimming level maximum value. Size: 1 Byte, Default Value: 99
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 4: Minimum level
To set dimming level minimum value. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 0 |
Parameter 5: Basic duration set
To set dimming finished duration. Size: 1 Byte, Default Value: 2
| Setting | Description |
|---|---|
| 0 | 0 |
Technical Data
| Hardware Platform | ZGM130S037HGN2 / ZGM130S037HGN1 |
| Device Type | Multilevel Switch DT |
| Network Operation | Always On Slave |
| Firmware Version | HW: 01 FW: 01.03:01.02 |
| Z-Wave Version | 7.16.3 |
| Certification ID | ZC14-22030080 |
| Firmware Updatable | Updatable by Consumer by RF |
| Color | White |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |