Quickstart
This is a
secure
Motorized Barrier DT for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
This is garage door controller allows users to wirelessly control and monitor their garage door. It monitors and reports the state of the garage door through use of a paired wireless (or wired) tilt sensor. It also determines when the garage door is active by utilizing an accelerometer to detect specific vibration patterns.
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
|
Technical Data
Hardware Platform |
ZGM130S037HGN2 / ZGM130S037HGN1 |
Device Type |
Motorized Barrier DT |
Network Operation |
Always On Slave |
Firmware Version |
HW: 01 FW: 01.00 |
Z-Wave Version |
7.15.4 |
Certification ID |
ZC14-21120036 |
Firmware Updatable |
Updatable by Manufacturer |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |