Quickstart

This is a Hardware Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Stick is a USB v2.0 full speed low power CDC-ACM compliant Z-Wave adapter in a thumb drive form factor. The Stick can act as a Z-Wave Controller when its connected to a host like PC, MAC or Gateway (some in the market) etc. With a certain program installed on the PC, it can add or remove devices in or from a network

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Hardware Platform ZGM130
Device Type Hardware Device
Network Operation N/A - Hardware Device
Firmware Version HW: 0 FW: ERROR
Z-Wave Version 7.15.1
Certification ID ZC12-21050232
Communications Protocol Z-Wave Serial API
Color White
Firmware Updatable Updatable by Professional/Technician
Controller Supports Multiple Networks ok
Communications Connections USB (Universal Serial Bus)
Frequency XXfrequency
Maximum transmission power XXantenna
Hardware Device