Jasco
Portable Smart Motion Sensor
SKU: 52251/ZW6307
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Make the move toward convenience with the Z-Wave Portable Smart Motion Sensor for your home. This Z-Wave compatible device boosts the safety of your home by working with your homes gateway to wirelessly trigger scenes and send alerts to your smartphone or tablet whenever motion is detected. Use the included batteries for easy placement anywhere, plug into the wall using a AC adapter andUSB cablenever replace batteries again.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | (lifeline group) Supports Device Reset locally and receives unsolicited status updates |
Configuration Parameters
Parameter 13: PIR Sensitivity
Configuration the motion sensitivity high medium or low Size: 1 Byte, Default Value: 3
| Setting | Description |
|---|---|
| 1 | Low Sensitivity |
| 2 | Medium Sensitivity |
| 3 | High Sensitivity |
Parameter 18: Motion timeout duration
Timeout duration Motion detect, when battery operated (1-60), when USB powered it is continually 5 seconds Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 1 - 60 | Timeout duration after detection in minutes |
| 127 | 5 seconds |
Parameter 19: alternate exclusion
Alternate exclusion mode press button one time or three times Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Classic inclusion |
| 1 | Alternate inclusion |
Parameter 20: Notification
Notification report Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 1 | Sensor will send out Notification |
Parameter 23: Battery report interval
Set the interval timer of battery report Size: 2 Byte, Default Value: 1440
| Setting | Description |
|---|---|
| 5 - 1440 | Interval between reports of battery level |
Parameter 28: Motion action blink LED
Disable or Enable Motion action blink LED Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Disable LED |
| 1 | Enabled |
Technical Data
| Hardware Platform | ZGM130 |
| Device Type | Notification Sensor |
| Network Operation | Reporting Sleeping Slave |
| Firmware Version | HW: 1 FW: 7.05 |
| Z-Wave Version | 7.13.5 |
| Certification ID | ZC12-20090125 |
| Z-Wave Product Id | 0x0063.0x4953.0x3238 |
| Firmware Updatable | |
| Z-Wave Scene Type | |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |