Danalock
Danalock V3-BTZH-ANZ
SKU: Danalock V3-BTZH-ANZ
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Danalock supports:- S0/S2 Z-Wave Security- Bluetooth Smart - Twist Assist- Auto-Lock- Hold And Release- End to End
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Z-Wave Plus Lifeline Device Reset Locally: triggered upon reset. Battery/notification: triggered upon low battery. Door Lock operation report: triggered upon a change in door lock Notification: triggered upon a change in door lock |
Configuration Parameters
Parameter 1: Twist Assist
Helps you to lock and unlock your door lock. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Disabled |
| 1 | Enabled |
Parameter 2: Hold and Release
After a unlock operation the lock holds the lock, so the door can be opened Size: 4 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Disable |
| 1 - 2147483647 | Enable no. of seconds |
Parameter 3: Block to Block
The lock will run the motor until it hits resistance. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Disable |
| 1 | Enable |
Parameter 4: BLE Temporary Allowed
The BLE is enabled for a number of seconds. Size: 4 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 1 - 2147483647 | Enable no. of seconds |
Parameter 5: BLE Always Allowed
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | BLE Always disabled |
| 1 | BLE Always enabled |
Parameter 6: Autolock
Lock after an unlock. The value is the delay in time before the lock is locked again. Size: 4 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Diable |
| 1 - 2147483647 | Enable no. of seconds |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Door Lock - Keypad |
| Network Operation | Listening Sleeping Slave |
| Firmware Version | HW: 2 FW: 1.03:00.10 |
| Z-Wave Version | 6.71.03 |
| Certification ID | ZC10-21107059 |
| Z-Wave Product Id | 0x010E.0x0009.0x0001 |
| Supported Notification Types | Access Control |
| Firmware Updatable | Updatable by Consumer by RF |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |