This is a
Z-Wave PlusIn-Wall Smart Receptacle replaces existing light switch and allows remote control from any Z-Wavecertified hub.
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
2 | 5 | Association Group 2 supports basic set and is controlled by single pressing the button |
3 | 5 | Association Group 3 supports basic set and is controlled by double pressing the button |
LED Light Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | LED On when load is Off, Led Off when load is On |
1 | LED On when load is On, LED Off when load is Off (Default) |
2 | LED always off |
Hardware Platform | ZM5202 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.51 |
Z-Wave Version | 6.82.00 |
Certification ID | ZC10-21107057 |
Z-Wave Product Id | 0x0458.0x4952.0x3235 |
Switch Type | Push Button Illuminated |
Neutral Wire Required | ok |
Firmware Updatable | Updatable by Consumer by RF |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |