Mini Smart Plug
SKU: N4001
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.Each module is designed to act as a repeater,which will re-transmit a radio frequency (RF) signal by routing the signal ,around obstacles and radio dead spots to ensure that the signal is received at its intended destination.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 3 | Z-Wave Lifeline |
| 2 | 5 | When the output of the N4001 socket is changed, On (0xFF) or Off (0x00). The N4001 will automatically send out a relatedb a s i c Osne t(0 cxoFmFm)a onrd. Off (0x00) to its associated group. |
Configuration Parameters
Parameter 1: Status LED
Status LED Configuration Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | LED on when relay on, LED off when relay off |
| 1 | LED on when relay off, LED off when relay on |
| 2 | LED Always OFF |
Parameter 2: Count Down Configuration
Count Down ConfigurationThe countdown time, the socket closed Size: 2 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 32767 | Countdown time can be set up for this time |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 255 FW: 1.255 |
| Z-Wave Version | 6.71.01 |
| Certification ID | ZC10-21087048 |
| Z-Wave Product Id | 0x0312.0xAC01.0x4001 |
| Firmware Updatable | Updatable by Consumer by RF |
| Color | White |
| Electric Load Type | FluorescentIncandescentLED |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |