JascoPro Series
LED Bulb
SKU: 64637/ZW7105
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Set the scene with the JascoPro Series Z-Wave Smart LED Bulb. When paired with a compatible hub, the smart bulb supports ON/OFF/dim commands and programmed settings. Wirelessly operate lamps, sconces, ceiling lights and other fixtures that use standard A19 bulbs for effortless management of your home. Your automation possibilities are seemingly infinite when connected to hubs from Ring, SmartThings, Wink, Vivint, HomeSeer, Honeywell, Fibaro, Trane, Nexia, ADT, Vera, eZLO and more!
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
Configuration Parameters
Parameter 1: Dim Level
Dim level when light bulb is turned ON Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 2 | Dim level when light bulb is turned ON |
Parameter 10: Dimming/Brightening Step Timing
Adjust Dim Speed Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 10 | Adjust Dim Speed |
Parameter 9: Dim Level
Dim level when light bulb is turned ON Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 1 - 99 | Dim level when light bulb is turned ON |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Light Dimmer Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 5.02 |
| Z-Wave Version | 6.82.01 |
| Certification ID | ZC10-21077046 |
| Z-Wave Product Id | 0x0063.0x4C42.0x3036 |
| Firmware Updatable | Updatable by Consumer by RF |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |