Ness
Scene Controller
SKU: ZA-207001
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Scene Controller is a wireless, portable and rechargeable scene switch. It can control a Z-Wave device, such as smart plug, smart dimmer with a Z-Wave gateway. You can also activate a scene like sleep scene, movie scene and entertainment scene with it.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | (Lifeline group) allows Scene Controller sends central scene notification command and battery report command when any button is triggered. Details shown as the below diagram 1. |
| 2 | 5 | allows Scene Controller sends basic set command when thebutton 1 is triggered |
| 3 | 5 | allows Scene Controller sends switch multilevel set, multilevel start level change and multilevel stop level change command when the button 1 is triggered. |
| 4 | 5 | allows Scene Controller sends basic set command when thebutton 2 is triggered. |
| 5 | 5 | allows Scene Controller sends switch multilevel set, multilevel start level change and multilevel stop level change command when the button 2 is triggered. |
| 6 | 5 | allows Scene Controller sends basic set command when thebutton 3 is triggered. |
| 7 | 5 | allows Scene Controller sends switch multilevel set, multilevel start level change and multilevel stop level change command when the button 3 is triggered. |
| 8 | 5 | allows Scene Controller sends basic set command when thebutton 4 is triggered. |
| 9 | 5 | allows Scene Controller sends switch multilevel set, multilevel start level change and multilevel stop level change command when the button 4 is triggered. |
Configuration Parameters
Parameter 254: Enable/disable the configuration command
Lock/unlock all configuration parameters. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Unlock all configuration parameters. |
| 1 | Lock all configuration parameters |
Parameter 255: Reset Scene Controller
Reset Scene Controller and remove from the Z-Wave network Size: 4 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 1431655765 | Reset Scene Controller and remove from the Z-Wave network |
Technical Data
| Hardware Platform | ZM5101 |
| Device Type | Wall Controller |
| Network Operation | Portable Slave |
| Firmware Version | HW: 1 FW: 1.00 |
| Z-Wave Version | 6.51.08 |
| Certification ID | ZC10-20106991 |
| Z-Wave Product Id | 0x0208.0x0202.0x000B |
| Z-Wave Scene Type | Central Scene |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |