Enbrighten
In-Wall 3-Speed Fan Control
SKU: 55258/ZW4002
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Transform any home into a smart home with the Enbrighten Z-Wave Smart Fan Control. The in-wall fan control easily replaces any standard in-wall switch remotely controls a ceiling fan in your home and features a three-speed control system. Your home will be equipped with ultimate flexibility with the Enbrighten Z-Wave Smart Fan Control, capable of being used by itself or with up to four Enbrighten add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches and the integrated LED indicator light allows you to easily locate the switch in a dark room. The Enbrighten Z-Wave Smart Fan Control is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with Enbrighten Z-Wave Smart Lighting Controls!
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
| 2 | 5 | Supports Basic Set and is controlled with the local load |
| 3 | 5 | Supports Basic Set and is controlled by double pressing the On or Off button |
Configuration Parameters
Parameter 4: Invert Switch
If mounted upside down, you can change the configuration for On to Off/ Off to On inputs Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Default |
| 1 | Invert |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Fan Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 255 FW: 5.50 |
| Z-Wave Version | 6.82.00 |
| Certification ID | ZC10-20086955 |
| Z-Wave Product Id | 0x0063.0x4944.0x3337 |
| Firmware Updatable | |
| Z-Wave Scene Type | |
| Neutral Wire Required | ok |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |