This is a
Transform any home into a smart home with the Resideo Z-Wave In-Wall Switch. The on/off switch replaces your current light switch, uses your existing wiring, and provides Z-Wave wireless and in-wall control of overhead lighting. The switch enables wireless control of on/off functions of direct wire incandescent, LED, xenon, halogen and fluorescent lighting. Providing ultimate flexibility, the Resideo Z-Wave Switch allows you to operate the switch by itself or easily integrate the switch with two-way, three-way or four-way wiring configurations by adding the Resideo Add-On switch. Single pole wiring configuration turns the light or appliance on/off from one location. Three-way wiring configuration turns the light on/off from two separate locations. Four-way wiring configuration turns the light on/off from three separate locations. The Resideo Add-On Switch is required for Three-way or Four-way installations. The lighting control includes a blue LED indicator light to easily locate the switch in a dark room. Take control of your home lighting with Resideo Z-Wave Smart Controls!
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Supports device reset locally and receives unsolicited status updates. |
2 | 5 | Association Group 2 supports Basic Set and is controlled by single pressing the button. |
3 | 5 | Association Group 3 supports Basic Set and is controlled by double pressing the button. |
Alternate exclusion Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Press any button on the switch |
1 | Press two times ON button and two times OFF button |
Invert/disable LED(Adjusts when the indicatorLED is turned ON, OFF ordisables it entirely) Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | LED ON/device OFF |
1 | LED ON/device ON |
2 | Disable LED |
Invert switch(In case switch isinstalled upside down) Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Default (Top ON/bottom OFF) |
1 | Invert switch (Top OFF/bottom ON) |
Hardware Platform | ZM5202 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.53 |
Z-Wave Version | 6.81.04 |
Certification ID | ZC10-20036899 |
Z-Wave Product Id | 0x041B.0x4952.0x3036 |
Firmware Updatable | Updatable by Consumer by RF |
Z-Wave Scene Type | Central Scene |
Neutral Wire Required | ok |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |