EcoDim BV
ECO-DIM.07 Z-Wave LED dimmer
SKU: ECO-DIM.07 Z-Wave
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
ECO-DIM.07 Z-Wave is a push/rotary dimmer for LED lights. The dimmer has a range of 0-200W LED, and is able to dim 230V halogen and incandescent bulds, dimable LED-drivers and electronic transfomers. The minimum and maximum light level of the dimmer can be adjusted via a potentiometer. It is protected against overload and interference signals. Installation can be done via 2 wires, there is no need for a neutral wire!It is suitable for most popular smarthome systems, and the frame systems of the most popular brands can be used: Busch-Jaeger, Merten by Schneider, Berker by Hager, Niko, Gira, Jung and Peha. The dimmer is compatible with 95% of all dimmable LED lights.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | The ASSIC of Lifeline: 4C 69 66 65 6C 69 6E 65General Lifeline, Profile, MSB=0x00, Profile LSB 0x01 |
Configuration Parameters
Parameter 1: State After Power Restored
The state the switch should return once power is restored after power failure Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Off |
| 1 | On |
| 2 | Returns to level before power usage |
Parameter 2: Notification when Load status change
The dimmer will send notification to associated device (Group lifeline) when the status of the Dimmer load is changed Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | The function is disabled |
| 1 | Send Switch Multilevel Report |
| 2 | Send Switch Multilevel Report only when Load status is not changed by Z-Wave command |
Technical Data
| Hardware Platform | ZM5101 |
| Device Type | Light Dimmer Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 1.17 |
| Z-Wave Version | 6.81.03 |
| Certification ID | ZC10-20036885 |
| Z-Wave Product Id | 0x0431.0x0202.0x0001 |
| Firmware Updatable | Updatable by Consumer by RF |
| Switch Type | Rotary Knob |
| Communications Connections | |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |