Quickstart
This is a
secure
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The Power Switch also serves as a router in the Z-Wave network. After being included in the Z-Wave network, it allows other Z-Wave device to join the network through the Power Switch.The Z-Wave Power Switches allow access to the S2 Unauthenticated class and support Z-Wave SmartStart inclusion as well as classic inclusion.
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Grouping 1 for LifeLine: (max node: 5)Switch Binary CC (COMMAND_CLASS_SWITCH_BINARY)Device Reset Locally CC (COMMAND_CLASS_DEVICE_RESET_LOCALLY)When toggling between On/Off, it will send Binary Switch Report to the nodes of Grouping 1. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
HW: 255 FW: 4.01 |
Z-Wave Version |
6.81.06 |
Certification ID |
ZC10-20016845 |
Z-Wave Product Id |
0x018E.0x0004.0x0001 |
Firmware Updatable |
Updatable by Consumer by RF |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |