Quickstart
This is a
secure
Sub Energy Meter for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The Power Switch Meter can further measure power consumption in kWh and W of the plugged in device and report the values to the Z-Wave network regularly to notify the user. The power consumption can also be transmitted simply with a button press
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
The Switch can be set to send reports to associated Z-Wave devices. It supports one association group with five node support for Grouping 1. For grouping 1, the Switch will report its latest status to Z-Wave Gateway/Panel. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Sub Energy Meter |
Network Operation |
Always On Slave |
Firmware Version |
HW: 255 FW: 4.01 |
Z-Wave Version |
6.81.06 |
Certification ID |
ZC10-19126809 |
Z-Wave Product Id |
0x018E.0x0004.0x0002 |
Firmware Updatable |
Updatable by Consumer by RF |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |