ABUS
ABUS Z-Wave Door-/Window Sensor
SKU: PLMK10000
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Z-Wave Door- / Window Sensor detects the opening of windows and doors and informs your smart home gateway. Thanks to an overall height of only 3 mm, installation in door or window frames is possiblesimply by adhesive mounting. When closed, the detector cannot be seen from the outside or inside.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Z-Wave Plus Lifeline Notification Report |
Configuration Parameters
Parameter 1: notification type (Door Open/Door Close)
Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Binary Sensor Report |
| 1 | Notification Report |
| 2 | Basic Report |
Parameter 2: LED indication
Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | Specific event indication detected (means: specific event detected(e.g. door opened) |
| 1 | On |
Parameter 3: Activate Supervision
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Off |
| 1 | Alarm Reports (means: specific event detected e.g. door opened) |
| 2 | Unsolicited Reports |
Technical Data
| Hardware Platform | ZM5101 |
| Device Type | Notification Sensor |
| Network Operation | Reporting Sleeping Slave |
| Firmware Version | HW: 3 FW: 4.04:00.03 |
| Z-Wave Version | 6.81.03 |
| Certification ID | ZC10-19126807 |
| Z-Wave Product Id | 0x0403.0x0003.0x0006 |
| Outdoor Use | ok |
| Color | |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |