Quickstart
This is a
secure
IR Repeater for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
The RS-ZWIREX1 is an IR repeater supporting the Z-Wave Plus standard. The RS-ZWIREX1 supports learning and repeating IR signals. The RS-ZWIREX1 also has a temperature and humidity sensor.The RS-ZWIREX1 is a security enabled Z-Wave Plus Product. This device must be used in conjunction with a Security Enabled Z-Wave Controller in order to fully utilize all implemented functions. The RS-ZWIREX1 supports the standard security S0 and S2.
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Z-Wave Plus LifelineSupports the following command classes: Device Reset Locally: triggered upon reset. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
IR Repeater |
Network Operation |
Always On Slave |
Firmware Version |
HW: 1 FW: 1.00:01.00 |
Z-Wave Version |
6.81.03 |
Certification ID |
ZC10-19116789 |
Z-Wave Product Id |
0x040F.0x0001.0x0001 |
Sensors |
Air TemperatureHumidity |
Firmware Updatable |
Updatable by Consumer by RF |
Color |
White |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |