MCO Home
Touch Panel Switch
SKU: MH-S510 series
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Touch Panel Switch is a wall panel built-in with Z-Wave Plus module. With its stylish design and stable performance, the panel can be used to control house-hold electrical appliances like lamp, motor, coffee machine, TV set etc. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from any other manufacturers.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | send status of all endpoints to gateway by COMMAND_CLASS_BASIC, BASIC_REPORT |
Configuration Parameters
Parameter 2: Parameter 1
0x00 not saved, switch will be off when powered again0x01 saved, switch will keep the same state when powered again Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 - 1 | Switch state saved or not when power failure |
Parameter 4: Parameter 2
0x00 LED disabled0x01~0x0A Min level-Max level Size: 1 Byte, Default Value: 10
| Setting | Description |
|---|---|
| 0 - 10 | LED Backlit brightness level |
Parameter 5: Parameter 3
0x00 single click to switch on/off status0x01 Key default as off state. When it is turned on, then it willbe turned off automatically after a time period , which can be set in item 0x060x02 Key default as on state. When it is turned off, then it willbe turned on automatically after a time period , which can be set in item 0x06 Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 2 | Key Mode |
Parameter 6: Parameter 4
0x00 infinite1~32767 unit u0022secu0022 Size: 2 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 32767 | Key On duration |
Parameter 7: Parameter 5
0x00 Button(Momentary button)0x01 Toggle(2-state switches) Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 1 | External aux-switch type |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 255 FW: 6.00 |
| Z-Wave Version | 6.71.03 |
| Certification ID | ZC10-19106776 |
| Z-Wave Product Id | 0x015F.0x5131.0x5101 |
| Neutral Wire Required | ok |
| Z-Wave Scene Type | |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |