keemple
Smart Touch Light Switch (2-way)
SKU: KP-SW-08
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Touch switch is an in-wall switchgear based on Z-Wave wireless radio frequency technology for intelligent control. This product can be added to the gateway or PC controller supporting Z-Wave Plus, remotely controlled through the APP interface, or manually controlled by the touch. In addition, the product also supports the scene mode, the user can configure the scene through the APP, combine various devices in the same scene, and run the scene function through the APP or manually.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
| 2 | 5 | scene control |
| 3 | 5 | Endpoint 1: Switch status report |
| 4 | 5 | Endpoint 2: Switch status report |
Configuration Parameters
Parameter 21: Setting device status after power failure
Define how the Switch reacts after the power supply is back on. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Touch Switch memorizes its state after a power failure. |
| 1 | Touch Switch does not memorize its state after a power failure. Connected device will be on after the power supply is reconnected. |
| 2 | Touch Switch does not memorize its state after a power failure. Connected device will be off after the power supply is reconnected. |
Parameter 24: Notification when Load status change
Touch Switch can send notifications to association device when state of Touch Switchs load change. Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | The function is disabled. |
| 1 | Send Switch binary report. |
| 2 | Send Switch binary report only when Load condition is not changed by Z-WAVE Command. |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 1.00 |
| Z-Wave Version | 6.81.03 |
| Certification ID | ZC10-19086710 |
| Z-Wave Product Id | 0x041A.0x0100.0x0003 |
| Color | White |
| Z-Wave Scene Type | Scene & Central Scene |
| Switch Type | Push Button with Indicator |
| Loads Controlled | 2 |
| Firmware Updatable | Updatable by Consumer via Internet |
| Electric Load Type | Dimmable ELV (Magnetic)Dimmable FluorescentDimmable LEDDimmable MLV (Magnetic)ELV (Electronic)FluorescentIncandescentInductive (e.g. Motor)LEDMLV (Magnetic) |
| Communications Protocol | Z-Wave Serial API |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |