Quickstart
This is a
secure
Door Lock - Keypad for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
-Follow the user guide of hub to enter inclusion mode.-Operate on lock following guide below:1.Enter master mode(refer to programming instruction)2.Input 8 to enter function extension settings3.Input 1 to join a network.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Lock and unlock your door anywhere and anytime by integrate your lock into your Z-Wave home automation or security system for ultimate convenience. Features Bluetooth technology for added convenience with auto-unlock.
| Reset to factory default |
Please use this procedure only when the network primary controller is missing or inoperable.-Operations on lock1.Open the door and keep the lock in "unlock" status2.Open battery box and find the reset button. 3.Use a sharp thing to press and hold the reset button.4.Keep holding the reset button and remove a battery from battery box then replace it.5.Keep holding the reset button until hearing voice guide. |
| Inclusion |
-Follow the user guide of hub to enter inclusion mode.-Operate on lock following guide below:1.Enter master mode(refer to programming instruction)2.Input 8 to enter function extension settings3.Input 1 to join a network. |
| Exclusion |
-Follow the user guide of hub to enter exclusion mode.-Operate on lock following guide below:1.Enter master mode(refer to programming instruction)2.Input 8 to enter function extension settings3.Input 2 to log off a network. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Z-Wave Plus Lifeline association group |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Door Lock - Keypad |
| Network Operation |
Listening Sleeping Slave |
| Firmware Version |
HW: 19 FW: 3.01:01.32 |
| Z-Wave Version |
6.71.03 |
| Certification ID |
ZC10-19056521 |
| Z-Wave Product Id |
0x021D.0x0003.0x0001 |
| Door Lock Type |
Deadbolt Motor Attachment |
| Firmware Updatable |
Updatable by Consumer by RF |
| Supported Notification Types |
Access Control |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
