Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
- Press a Func_Button 3 time in the Door Sensor, Green LED is Blinking 3 times within 1 second.- If Inclusion Process is successful, Green led will turn off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
This smart door sensor is consists of sensor part and magnet part. It can sense the open and close state of the door and windows, once there is unexpected intruder, it will send alarm information to the user APP.It has mini stylish design,easy installation and long lifespan.
Reset to factory default |
- Long press Func_Button while installing batteries in HS1DS-Z - Device Reset Locally notification is Transmitted- Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
Inclusion |
- Press a Func_Button 3 time in the Door Sensor, Green LED is Blinking 3 times within 1 second.- If Inclusion Process is successful, Green led will turn off. |
Exclusion |
-Press a Func_Button 3 times quickly.-If Exclusion Process is successful, Green led is Blinking 6 times, then turn off. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Association group 1: Lifeline association groupInclude command classe: Battery report, Notification report, and Device Reset Locally notification, Binary report. |
2 |
5 |
Association group 2: Root Device group(Binary Sensor)Binary Sensor Command Class:Compatible with 300 series1-Binary Sensor reports status of open or close door via Lifeline.2- When the sensor detects status change between close door and open door, the device will be triggered. |
3 |
5 |
Association group 3: Root Device group(Binary Sensor)Binary Sensor Command Class:Compatible with 300 series1-Binary Sensor reports the removed status of door sensor.2-When the sensor detects status change of tamper, the device will be triggered. |
4 |
5 |
Association group 4: Root Device group(Notification)1-Notification report open door or close status via Lifeline.2- When the sensor detects status change between close door and open door, the device will be triggered. |
5 |
5 |
Association group 5: Root Device group(Notification)1-Binary Sensor reports the removed status of door sensor.2- When the sensor detects status change of tamper, the device will be triggered. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 255 FW: 1.37 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-19056494 |
Z-Wave Product Id |
0x041C.0x0168.0x0168 |
Color |
White |
Supported Notification Types |
Smoke Alarm |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |