Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
-Press Func_Button 3 time in the motion sensor, Green LED is Blinking 3 times within 1 second.-If Inclusion Process is successful, Green LED will turn off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
This Smart Motion Sensor adopts automatic threshold adjustment technology to enhance the stability of the detector, efficiently decrease false alarms. Automatic temperature compensation technology can efficiently prevent detectors from the sensitivity decrease resulted from the temperature variation.Its suitable to be used for safety protection of residential, villas, factories, shopping malls, warehouses, officebuildings, banks, computer room and other places.
| Reset to factory default |
-Long press Func_Button while installing batteries -Device Reset Locally notification is Transmitted-Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
| Inclusion |
-Press Func_Button 3 time in the motion sensor, Green LED is Blinking 3 times within 1 second.-If Inclusion Process is successful, Green LED will turn off. |
| Exclusion |
-Press Func_Button 3 times quickly.-If Exclusion Process is successful, Green LED is Blinking 6 times, then turn off. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Association group 1: Lifeline association groupInclude command classe: Battery report, Notification report, and Device Reset Locally notification, Binary report. |
| 2 |
5 |
Association group 2: Root Device group(Binary Sensor)Binary Sensor Command Class:Compatible with 300 series. 1-Report status of people passing by, no people passing by, tamper alarm and tamper recovery via lifeline. 2- When the Device detects new event of people passing by or no people passing by, tamper alarm and tamper recovery, the device will be triggered. |
| 3 |
5 |
Association group 3: Root Device group(Notification)1-Report status of people passing by, no people passing by, tamper alarm and tamper recovery through lifeline. 2- When the Device detects new event of people passing by or no people passing by, tamper alarm and tamper recovery, the device will be triggered. |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Notification Sensor |
| Network Operation |
Reporting Sleeping Slave |
| Firmware Version |
HW: 255 FW: 1.37 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-19056485 |
| Z-Wave Product Id |
0x041C.0x8001.0x1000 |
| Sensors |
Motion/No Motion (Binary) |
| Communications Protocol |
Z-Wave Serial API |
| Supported Notification Types |
Access Control |
| Color |
White |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
