Quickstart
This is a
secure
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
-Click [Add] icon in Z-Wave Controller.-Press the SW_Button 3 times within 1.5s, Blue LED is Blinking 3 times within 1 second.-If add Process is successful, Blue LED will turn off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Remote controlled socket with energy meter can be used with lamps, fans and other devices.Uses Z-Wave with S2 Security
Reset to factory default |
- Long press SW_Button at least 10 seconds. - Device Reset Locally notification is Transmitted.-Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
Inclusion |
-Click [Add] icon in Z-Wave Controller.-Press the SW_Button 3 times within 1.5s, Blue LED is Blinking 3 times within 1 second.-If add Process is successful, Blue LED will turn off. |
Exclusion |
-Click [Remove] icon in Z-Wave Controller. -Press the SW_Button 3 times within 1.5s -If remove Process is successful, blue LED is Blinking 6 times, then turn off. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Association & Association Group Information-Lifeline between controller and the product- Maximum supported node is 5- Association Group descriptionAssociation group 1: Lifeline association groupInclude command classes: Switch Binary report, Meter Report and Device Reset Locally notification. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
HW: 255 FW: 3.01 |
Z-Wave Version |
6.71.03 |
Certification ID |
ZC10-19046437 |
Z-Wave Product Id |
0x041C.0x8006.0x1000 |
Supported Meter Type |
Electric Energy |
Color |
White |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |