This is a
A.) Screw the LED bulb into a standard E27 socket.B.) Click the + (Add) button in your Z-Wave App and follow the further instructionsC.) Turn the light-switch on. The App will show if the Add device process was successful and the LED-bulb will flash once. Repeat the inclusion process from step B if it was not successful.
The ABUS Z-Wave LED/RGBW Light Bulb is dimmable, provides configurable light colour (RGBW) and light temperature (warm white / cold white). The Bulb fits into any E27 socket and includes a repeater function for extending the range of the Z-Wave radio signal.
Reset to factory default | 1. Switch the Power supply oft he LED bulb ON and OFF 6 times in a row. (Interval of 0.5 to 2 seconds)2. When switched on for the 7th time, the LED bulb flashes twice indicating successful reset to factory settings.Note: 1, This procedure should only be used if the primary gateway is not capable of acting. 2, If the multi-sensor is set to the factory setting, the status is set to "not included", the association settings and possible configurations are reset to default. |
Inclusion | A.) Screw the LED bulb into a standard E27 socket.B.) Click the + (Add) button in your Z-Wave App and follow the further instructionsC.) Turn the light-switch on. The App will show if the Add device process was successful and the LED-bulb will flash once. Repeat the inclusion process from step B if it was not successful. |
Exclusion | A.) Click the - (Remove) button in your Z-Wave App and follow the further instructions.B.) Switch the LED bulb on. The App will show if the Remove device process was successful. The LED bulb will flash once and then dim to 5%. Repeat the exclusion process from step A if it was not successful. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 1 | Z-Wave Plus Lifeline |
Size: 4 Byte, Default Value: 0
Setting | Description |
---|---|
-2004318072 - 0 | Reset to factory configuration and removed the Z-Wave network |
-2013265920 - 0 | Reset Configuration parameter to default value. |
Hardware Platform | ZM5101 |
Device Type | Light Dimmer Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 2.23 |
Z-Wave Version | 6.51.09 |
Certification ID | ZC10-18106286 |
Z-Wave Product Id | 0x0403.0x0003.0x0001 |
Firmware Updatable | Updatable by Manufacturer |
Communications Protocol | Manufacturer Proprietary Protocol |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |