This is a
Plug the Z-Stick into USB port of your host Controller and then click the Learn button on yourPC/host Controller application.
AeotecZ-Stick Gen5 is a USB controller. When connected to a host controller via USB, it enables the host controller to take part in the Z-Wave network.Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Reset to factory default | Use this procedure only in the event that the primary controller is missing or otherwise inoperable.Press and hold the Action Button on Z-Stick for 20 seconds and then release. |
Inclusion | Plug the Z-Stick into USB port of your host Controller and then click the Learn button on yourPC/host Controller application. |
Exclusion | Plug the Z-Stick into USB port of your host Controller and then click the Learn button on yourPC/host Controller application. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
As long as this device is not included into a Z-Wave network of a different controller it is able to manage its own Z-Wave network as primary controller. As a primary controller the device can include and exclude other devices in its own network, manage associations, and reorganize the network in case of problems. The following controller functions are supported:
Communication between two Z-Wave devices only works if both belong to the same wireless network. Joining a network is called inclusion and is initiated by a controller. The controller needs to be turned into the inclusion mode. Once in this inclusion mode the other device needs to confirm the inclusion - typically by pressing a button.
If current primary controller in your network is in special SIS mode this and any other secondary controller can also include and exclude devices.
To become primary a contoller have to be resetted and then include a device.
Plug the Z-Stick into USB port of your host Controller and then click the Inclusion button on yourPC/host Controller application.
The primary controller can exclude devices from the Z-Wave network. During exclusion the relationship between the device and the network of this controller is terminated. No communication between the device and other devices still in the network can happen after a successful exclusion. The controller needs to be turned into the exclusion mode. Once in this exclusion mode the other device needs to confirm the exclusion - typically by pressing a button.
Attention: Removing a device from the network means that it is turned back into factory default status. This process can also exclude devices from it's previous network.
Plug the Z-Stick into USB port of your host Controller and then click the Exclusion button on yourPC/host Controller application.
Hardware Platform | ZM5101 |
Device Type | Hardware Device |
Network Operation | Hardware Device |
Firmware Version | HW: 90 FW: ERROR |
Z-Wave Version | 6.51.10 |
Certification ID | ZC10-18106274 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |