This is a
B.) Set the Gateway/Controller into inclusion mode (Click the + (Add) button in your Z-Wave App and follow the further instructions)
C.) Press the Network-button 3 times within 1.5 seconds and the Status-LED will flash 3 times
D.) If the Add device process is successful, the Status-LED will turn off.E: Repeat the inclusion process from step B if it was not successful.
The Z-Wave Indoor Siren comes with a High-volume siren (95dB) and LED strobe light for alarms with deterrent effect. In even of alarm, the siren can operate 5 minutes even unplugged due to its integrated backup-battery. A repeater function for extending the range of the Z-wave radio signal is also included.
1. Network Button
2. Siren
3. Connector
4. Flash light
Reset to factory default | Press the Network-button for 10 seconds to factory reset the device |
Inclusion | A.) Plug the SHSG10000 into a socket B.) Set the Gateway/Controller into inclusion mode (Click the + (Add) button in your Z-Wave App and follow the further instructions) C.) Press the Network-button 3 times within 1.5 seconds and the Status-LED will flash 3 times D.) If the Add device process is successful, the Status-LED will turn off.E: Repeat the inclusion process from step B if it was not successful. |
Exclusion | A.)Set the Gateway/Controller into exclusion mode (Click the - (Remove) button in your Z-Wave App and follow the further instructions) B.) Press the Network-button 6 times within 1.5 seconds and the Status-LED will flash 3 times If the Remove device process is successful, the Status-LED flash 6 times. C.) Repeat the inclusion process from step B if it was not successful. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Lifeline association group Include command classes: Switch Binary report ,Battery and Device Reset Locally notification. |
Dimensions | 0.0370000x0.0720000x0.0220000 mm |
Weight | 121 gr |
Hardware Platform | ZM5202 |
EAN | 4003318841514 |
IP Class | IP 20 |
Voltage | 230V |
Device Type | Siren |
Network Operation | Always On Slave |
Z-Wave Version | 6.71.03 |
Certification ID | ZC10-18096243 |
Z-Wave Product Id | 0x0403.0x0003.0x0000 |
Color | White |
Firmware Updatable | Updatable by Consumer by RF |
Outdoor Use | ok |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |