Dome
Range Extender
SKU: DMEX1
Quickstart
This is a
Turn the primary controller of Z-Wave network into inclusion mode, press the Z-Wave Button on Range Extender 3 times
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Dome Range Extender is designed to improve communication between Z-Wave devices. It amplifiesZ-Wave signals and increases the reach of your controller, ensuring your devices stay connected. TheExtender has an LED light that works as a nightlight and can also act as an indicator in regular mode.The included suction cup lets you mount the Extender onto any smooth surface while using a micro USBpower supply. All these features make the Dome Range extender the perfect choice for your home.
| Reset to factory default | Press and hold the Z-Wave Button for 10 seconds and then release it.Use this procedure only in the event that your primary network controller is missing or inoperable. |
| Inclusion | Turn the primary controller of Z-Wave network into inclusion mode, press the Z-Wave Button on Range Extender 3 times |
| Exclusion | Turn the primary controller of the Z-Wave network into exclusion mode, press the Z-Wave Button on Range Extender 3 times. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
Configuration Parameters
Parameter 1: Night Light "Off" Threshold
This parameter sets the luminance (brightness) level at which night light is turned off. This isa unitless value that can be set to any value from 0 - 10, with a default value of 5. The higherthis value, the brighter the ambient light must be to turn off the night light. Size: 1 Byte, Default Value: 5
| Setting | Description |
|---|---|
| 0 - 10 | Night light OFF Threshold |
Parameter 2: Night Light "On" Threshold
This parameter sets the luminance (brightness) level at which night light is turned on. This isa unitless value that can be set to any value from 0 - 10, with a default value of 5. The higherthis value, the brighter the ambient light must be to turn on the night light. Size: 1 Byte, Default Value: 5
| Setting | Description |
|---|---|
| 1 - 10 | Night light ON Threshold |
Technical Data
| Hardware Platform | ZM5101 |
| Device Type | Repeater |
| Network Operation | Always On Slave |
| Firmware Version | HW: 1 FW: 1.01 |
| Z-Wave Version | 6.71.01 |
| Certification ID | ZC10-18076183 |
| Z-Wave Product Id | 0x021F.0x0003.0x0108 |
| Firmware Updatable | Updatable by Consumer by RF |
| Color | White |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |