Jasco Products Company
Plug-in Smart Switch, Dual Plug
SKU: 28172/ZW4104
Quickstart
This is a
1. Follow the instructions for your Z-Wave certifiedcontroller to add the device to the Z-Wave network.2. Once the controller is ready to add your smartswitch, single press and release the manual/programbutton on the smart switch to add it in the network.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Transform any home into a smart home with the Jasco Z-Wave Smart Lighting Control and Appliance Module. The lighting control enables wireless control of on/off functions for standard table and floor lamps, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. Easily controlled by your mobile device or computer using any Z-Wave certified gateway, the space-saving horizontal module plugs into a standard wall receptacle without blocking the second outlet or obstructing placement of furniture. It provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control and a regular pass-through AC outlet for other electrical appliances. Perfect for plug-in fans, heaters, lamps and more! Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
| Reset to factory default | 1. If plugged in, unplug the switch from the receptacle.2. Press and hold the top button for at least 3 secondswhile you plug the switch into a receptacle.Note: This should only be used in the event your networksprimary controller is missing or otherwise inoperable. |
| Inclusion | 1. Follow the instructions for your Z-Wave certifiedcontroller to add the device to the Z-Wave network.2. Once the controller is ready to add your smartswitch, single press and release the manual/programbutton on the smart switch to add it in the network. |
| Exclusion | Follow the instructions for your Z-Wavecertified controller to remove a devicefrom the Z-Wave network.2. Once the controller is ready to remove your device,press and release the manual/program button onthe smart switch to remove it from the network. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
| 2 | 5 | Supports Basic Set and is controlled with the local load. |
| 3 | 5 | Supports basic set and is controlled by double pressing the button. |
Configuration Parameters
Parameter 3: LED Light
Adjust LED light to ON when Device is OFF or Disable the LED. Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 0 | LED On When Device Is OFF |
| 1 | Default LED On WHen Device Is On |
| 2 | Disable LED |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | On/Off Power Switch |
| Network Operation | Always On Slave |
| Firmware Version | HW: 255 FW: 5.22 |
| Z-Wave Version | 6.51.10 |
| Certification ID | ZC10-18066169 |
| Z-Wave Product Id | 0x0063.0x5052.0x3039 |
| Firmware Updatable | Updatable by Consumer by RF |
| Electric Load Type | IncandescentInductive (e.g. Motor)LED |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |