Quickstart
This is a
secure
Barrier Operator for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Place your Z-Wave Controller into Include mode.2. Press and release the link button on the GD00Z-6.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The GoControl GD00Z-6 is the next iteration of the best selling line of Z-Wave controlled remote garage door status indicator and activator.Adding S2 security and OTA capability, the GD00Z-6 continues to Norteks leadership positing in the IOT market. Open or close a sectional garage door remotely through a Z-Wave certified Gateway or Security Panel. Compatible with virtually any garage door opener connected to a sectional garage door. Audible and visual warnings prior to remotely-activated door movement, meeting UL 325 safety requirements. Included tilt sensor reports door "open" or "close" information.
Reset to factory default |
Reset the GD00Z-6 by pressing the LINK button 5 times. A quick beep followed by a longer beep will indicate the reset.Reset should only be used in the case of a missing or inoperative primary controller. |
Inclusion |
1. Place your Z-Wave Controller into Include mode.2. Press and release the link button on the GD00Z-6. |
Exclusion |
1. Place your Z-Wave Controller into Exclude mode.2. Press and release the link button on the GD00Z-6. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Barrier Operator |
Network Operation |
Always On Slave |
Firmware Version |
HW: 3 FW: 3.00:03.00 |
Z-Wave Version |
6.71.00 |
Certification ID |
ZC10-18066150 |
Z-Wave Product Id |
0x014F.0x4744.0x3531 |
Firmware Updatable |
Updatable by Consumer by RF |
Supported Notification Types |
Access Control |
Color |
Black |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |