Quickstart
This is a
secure
Repeater for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1Refer to your primary controller to enter into the Inclusion Mode or Exclusion Mode2When it is prompted to enter it, please triple click the PROG button within 1 second.Blue Indicator flashes TWICE then stay off
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
ZRP-200 is a Z-Wave repeater with best RF performance to replicate Z-Wave signals in a network. The repeater re-transmits an input Radio Frequency (RF) signal by routing the signal around obstacles and radio dead spots to ensure that the signal is received at its intended destinations. ZRP-200 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
| Reset to factory default |
Press and Hold PROG button for 3 seconds on Z-Wave Slim Repeater, the indicator will light up Purple Color. DO NOT Release the PROG Button until indicator change back to Blue color and flashes TWICE.Remark : All the Setting and Data will be permanently deleted. *Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
| Inclusion |
1Refer to your primary controller to enter into the Inclusion Mode or Exclusion Mode2When it is prompted to enter it, please triple click the PROG button within 1 second.Blue Indicator flashes TWICE then stay off |
| Exclusion |
1Refer to your primary controller to enter into the Inclusion Mode or Exclusion Mode2When it is prompted to enter it, please triple click the PROG button within 1 second.Blue Indicator flashes TWICE then stay off |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
1 |
Association Group #1 (max. 1 node) is default to associate with the primary controller (Gateway/Hub/Controller) for Z-Wave Repeater Status change report, refer to below for report details:a)Device Reset Locally Notification (Only report when the Z-Wave Repeater has been triggered the RESET TO DEFAULT) |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Repeater |
| Network Operation |
Always On Slave |
| Firmware Version |
HW: 1 FW: 0.10 |
| Z-Wave Version |
6.71.01 |
| Certification ID |
ZC10-18026028 |
| Z-Wave Product Id |
0x5254.0x1009.0x8180 |
| Color |
White |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
