This is a
1. Follow the instructions for your Z-Wave certifiedcontroller to add a device to the Z-Wave network.2. Once the controller is ready to add your device, press andrelease the Program Button to add it in the network.
Transform any home into a smart home with the GE Z-Wave Tamper Resistant Smart Outlet. The GE Z-Wave Tamper Resistant Smart Outlet enables wireless control of on/off functions from the Z-Wave controlled outlet, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. The tamper resistant duplex receptacle includes a blue LED indicator light to easily locate the receptacle in a dark room. The receptacle replaces your current electrical outlet, uses your existing wiring and provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control and a standard pass-through AC outlet for other electrical appliances. Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
Reset to factory default | Press the button 3 times, then press and hold the button for at least 3seconds. The LED will blink 5 times to confirm.NOTE: This should only be used in the event your networks primarycontroller is missing or otherwise inoperable |
Inclusion | 1. Follow the instructions for your Z-Wave certifiedcontroller to add a device to the Z-Wave network.2. Once the controller is ready to add your device, press andrelease the Program Button to add it in the network. |
Exclusion | 1. Follow the instructions for your Z-Wave certified controller toremove a device from the Z-Wave network.2. Once the controller is ready to remove your device, press andrelease the manual/program button to remove it from thenetwork. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
2 | 5 | Supports Basic Set and is controlled with the local load |
3 | 5 | Supports Basic Set and is controlled by pressing the On or Off button |
Invert LED Light Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | LED On when load is Off, Led Off when load is On |
1 | LED On when load is On, LED Off when laod is Off (Default) |
2 | LED always off |
Hardware Platform | ZM5202 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.24 |
Z-Wave Version | 6.51.09 |
Certification ID | ZC10-18025987 |
Z-Wave Product Id | 0x0063.0x4952.0x3133 |
Firmware Updatable | Updatable by Consumer by RF |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |