Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
1) Put the Z-Wave Controller into inclusion mode2) Press the Push button one time in door sensor
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
MC01-1702OPS offers information whether a door is open or closed.This is a battery-powered device, which is in sleeping mode unless an action is detected.After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping mode.Batteries can be changed with screwing the device from the frame.The device needs to be included into a Z-Wave network by the Z-Wave controller.
Reset to factory default |
1) Press the Push button for more than 10 seconds2) Verify that LED is blinking one time Please use this procedure only when the network primary controller is missing or otherwise inoperable |
Inclusion |
1) Put the Z-Wave Controller into inclusion mode2) Press the Push button one time in door sensor |
Exclusion |
1) Put the Z-Wave Controller into exclusion mode2) Press the Push button three times in door sensor |
NIF |
XXXNIF |
Wakeup |
There are 2 ways;When press the Push button two timeswhen the door state changes, e.g,. Open or Close-Minimum Wake Up Interval : 0 seconds-Maximum Wake Up Interval : 4200 seconds(70 minutes)-Default Wake Up Interval : 4200 seconds(70 minutes)-Wake Up Interval Step Seconds : 10 seconds |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5101 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 1 FW: 1.01 |
Z-Wave Version |
6.61.01 |
Certification ID |
ZC10-17125911 |
Z-Wave Product Id |
0x022D.0x0401.0x0101 |
Supported Notification Types |
Access Control |
Firmware Updatable |
Updatable by Consumer via Internet |
Color |
White |
Sensors |
Open/Closed (Binary) |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |