Quickstart
This is a
secure
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
1.Put the Z-Wave Controller into inclusion mode.2.Press the link button 3 times within 1.5 seconds to put the unit into inclusion mode.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
AXIS T8343 Alert Button is a wireless push button which relays events such as notification messages, illumination and much more. With its support for wireless input/output connectivity, the alert button can communicate wirelessly with AXIS M5065 PTZ Network camera or other connected Z-Wave Plus controllers, creating a small security solution with less cabling. Thanks to its integrated wireless I/O connectivity, AXIS T8343 enables flexible installation as the relay can easily be moved and adapted to your needs.
Reset to factory default |
Please use this procedure only when the network primary controller is missing or otherwise inoperable.1. Press the link button 3 times within 1.5 seconds to put the unit into exclusion mode.2. Within 1 second of step 1, press the link button again and hold for 5 seconds.3. Node ID is excluded. The device reverts to factory default state. |
Inclusion |
1.Put the Z-Wave Controller into inclusion mode.2.Press the link button 3 times within 1.5 seconds to put the unit into inclusion mode. |
Exclusion |
1. Put the Z-Wave Controller into exclusion mode.2. Press the link button 3 times within 1.5 seconds to put the unit into exclusion mode. |
NIF |
XXXNIF |
Wakeup |
After it has been included into a Z-wave network, the detector will go to sleep but will send a Wakeup Notification Command periodically at preset period to the controller. The detector will stay awake for 10 seconds at least and then go back to sleep to conserve battery life.The time interval between Wakeup Notification Commands can be set in the Wakeup Command Class based on the range values below: Minimum Wake Up Interval600s (10 minutes)Maximum Wake Up Interval86400s (1 day)Default Wake Up Interval14400s (4 hours)Wake Up Interval Step Seconds600s (10 minutes) |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Association with 1 node. |
2 |
4 |
Association with 4 nodes. |
Technical Data
Hardware Platform |
SD3502 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 1 FW: 1.01:00.01 |
Z-Wave Version |
6.71.01 |
Certification ID |
ZC10-17115879 |
Z-Wave Product Id |
0x0364.0x0005.0x0001 |
Color |
White |
Firmware Updatable |
Updatable by Consumer via Internet |
Supported Notification Types |
Appliance |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |